Replacing Water Pump Indicator Light
Water pump indicator lightAre you tired of replacing that expensive water pump indicator light that is visible only when you’re standing directly in front of it?
After having the third one in three years burn out in my motorhome, I went to RadioShack and found a 12-Volt, Hi-Brightness Red Lamp Assembly with Bulb (part #272-331) that came in a package of two for $2.29. The average life stated on the package is 25,000 hours. This LED is unbelievably bright and visible at a 90-degree angle along the length of the coach.
Rather than fabricate a new mounting template, I simply drilled out the existing rectangular plastic lamp to the 9/32-inch mounting hole necessary, inserted the new assembly, and soldered it to the existing wires. The assembly is just long enough to protrude 3/8-inch for easy visibility. I was able to access the rear of the template in the bathroom cabinet. But be careful to examine the drilled hole and make sure the old wires are cleaned out so you don’t experience any shorts to the circuit.
For $1.25, it’s one of the best bargains for your coach. The leftover assembly can be used for any other 12-volt indicator you might wish to install.
Jim Schenck, F184126
Lubbock, Texas
Wine Bottle Holder
Wine bottle holderMy wife and I like to enjoy a bottle of wine from time to time. We have found that a vinyl shoe holder we purchased from a camping store works perfectly for keeping our bottles safe. Opened bottles remain upright and do not bang together. We used short wood screws to attach it inside a closet near the kitchen dining area. When empty, it takes up no room at all.
Danny Lindstrom, F310275
Castroville, California
Compartment Closure
Sealing generator with 1/4-inch wire meshThe storage bays that hold the generator and the spare tire in my coach, and possibly others, are open to the ground. When dry camping in places such as Arizona, my biggest concern is rattlesnakes climbing inside. To avoid a “surprise” upon opening the generator compartment, I sealed it (and the spare tire area) with 1/4-inch wire mesh.
Measure the square footage of the bottom of the compartments and purchase an appropriate amount of wire mesh. I used sheet-metal screws and 1/4-inch washers to attach the mesh to the compartment. Measure the bay being enclosed, cut the wire mesh, and mark the places where it will be attached. Use a drill with a bit slightly smaller than the screws to start the holes. Attach the wire screen and, voila “” you’re safe from mice, snakes, and other vermin.
Horace L. Searcie, F301360
FMCA Mail Forwarding